THis is a decent 3″ oldschool big daddy. BUT THERE WAS A HEAD STRIKE DURING PRINTING.. it is on the very edge of 2 of the fin decals… you trim these to fit so you would probably cut most of the bad stuff off.. but not positive… the head strike is like a few little black smudges mostly see through. but defiantly can be seen! if you fly your rocket hard.. this is probably less than most hanger rash I have on my stuff LOL
REMEMBER anything in the BARGAIN BIN is sold AS IS.. they will be good usable decals (unless otherwise stated) BUT I can NOT modify them .. what you see is what you get!
Additional information
Choose one
Brown (live) on CLEAR, Brown (live) on WHITE, Blue (inert) on Clear
Circumferenceis the distance around the outside of a circle – or in our case, a tube. It is calculated by multiplying pi times the diameter.
Circle Circumference DiameterCircumference
In rocketry, there are so many different sized tubes out there. Just because a tube is advertised as a 2″ tube doesn’t mean it’s actually 2″. Some manufacturers’ 2″ tubes are actually 1.9″ (like Aerotech). Estes made a BT67 that was 2.02″ and a BT70 that was 2.217″. For a long time, standard 5.5″ tube was actually 5.38″, for example. For this reason, there are far too many circumference sizes to list each one, so we ask you to provide a circumference.
PLEASE ALSO REMEMBER WHAT A TUBE IS ADVERTISED TO BE IS ALMOST NEVER CORRECT! it may say its a 4″ tube but chances are its either 3.91 or 4.12″ (these are BOTH very common)
When finding your circumference, DO NOT simply “do the math” or use calipers to take your measurement then do the math. More often than not, you’ll squeeze the tube (even just a tiny bit) when measuring diameter/radius, which will give you the wrong number right from the get-go and your math will be wrong, ACTUALLY IT WILL MULTIPLY YOUR SMALL ERROR BY 3.1415 NOW making it a HUGE error. (if you squeeze your tube just 1/8″ you will be off by almost 1/2″ when doing the math!!!!) . Instead, please physically wrap something (such as a piece of paper, tape or measuring tape) around your tube, mark it, and measure it to get an exact circumference. (THIS METHOD WILL ALWAYS BE CORRECT EVEN IF YOU SMASH THE TUBE BY 2 INCHES!) Then, when you make your order, select the closest Diameter size listed and then enter your exact circumference measurement! That way, we can adjust the decal size to fit your tube exactly!
SO THE BEST WAY TO GET AN ACCURATELY FIT DECAL TO YOUR ROCKET, USE SOMETHING AND MEASURE AROUND YOUR FINISHED TUBE, THIS IS FAST AND EASY AND ALW@AYS ACCURATE!
IF your tube is a standard tube with no extra fiberglass or super thick paint etc. you can enter ” MADCOW THINWALL FIBERGLASS” or “PML PHENOLIC TUBE” etc I do have measurements for MOST standard HIGH POWER tubes. BUT entering your TRUE Circumference will ALWAYS give you the BEST matched decal for your rocket.
