FAQ

Circumference

Most rocketry body tubes are standard sizes, but some people either don’t use a standard tube, add fiberglass to them or have an odd-sized tube to start with. For that reason, we cannot be sure what size your rocket tube is unless you tell us. There are just way too many different possible sizes to list them all. By entering your circumference, we can match your decal to your rocket tube exactly. If you do not enter a circumference, we will assume your tube is standard sized (like LOC or PML) and make your decals to fit. If you choose not to provide a circumference and your decal doesn’t end up fitting your rocket, it will not be covered under warranty!  You may also enter  “wildman tube”  or “madcow thin wall fiberglass”  or similar.if it is a standard tube  with nothing special done to it (no extra fiberglass.. just simple paint etc)

Category: Circumference

Circumference is the distance around the outside of a circle – or in our case, a tube. It is calculated by multiplying pi times the diameter.

 

Circle Circumference Diameter
Circle Circumference Diameter

Circumference
Circumference

In rocketry, there are so many different sized tubes out there. Just because a tube is advertised as a 2″ tube doesn’t mean it’s actually 2″. Some manufacturers’ 2″ tubes are actually 1.9″ (like Aerotech). Estes made a BT67 that was 2.02″ and a BT70 that was 2.217″. For a long time, standard 5.5″ tube was actually 5.38″, for example. For this reason, there are far too many circumference sizes to list each one, so we ask you to provide a circumference.

When finding your circumference, DO NOT simply “do the math” or use calipers to take your measurement. More often than not, you’ll squeeze the tube (even just a tiny bit) when measuring diameter/radius, which will give you the wrong number right from the get-go and your math will be wrong. Instead, please physically wrap something (such as a piece of paper, tape or measuring tape) around your tube, mark it, and measure it to get an exact circumference. Then, when you make your order, select the closest Diameter size listed and then enter your exact circumference measurement! That way, we can adjust the decal size to fit your tube exactly!

IF your tube is a standard tube with no extra fiberglass or super thick paint etc. you can enter ” MADCOW THINWALL FIBERGLASS” or “PML PHENOLIC TUBE” etc I do have measurements for MOST standard HIGH POWER tubes. BUT entering your TRUE Circumference will ALWAYS give you the BEST matched decal for your rocket.

 

Category: Circumference

We guarantee our decals will fit your tube, based on the circumference you provide to us when ordering. If for whatever reason your decal still doesn’t fit, we will do what it takes to resolve the issue and get you a new one, so long as you have checked the box stating that you have read the instructions for determining your circumference and have done so correctly, and provided us with that circumference. Orders made without providing a specific circumference or verifying that you have read the instructions for how to determine the circumference of your tube will not be guaranteed, so if they don’t fit, you will be responsible for re-measuring and re-purchasing a replacement decal.

Category: Circumference